Leave it off for the initial testing phase if you have installed or clamped it on the CNC machine. The milling spindle motor has an On/Off switch on the spindle itself. I am sure you want to make the machine move first, just to see.) Check that the power on and PC lights are lit on the stepper controller unit when the software is running. (the T-Groove bed installation you can do at leisure. Step back and enjoy the feeling of seeing the Machine ready to go. Select the correct model and language from the tabs. A drop-down tab will allow you to choose which machine you have purchased. Now you can start the WinPC-NC program for the first time. The found new hardware - security key dialog should come up on the PC. For WinPCNC ECO Once the software is installed, insert the USB dongle supplied with WinPC-NC into a free USB port on the PC.

Now power up the PC and install the WinPC-NC software. If you are using the USB converter PLEASE INSTALL SOFTWARE BEFORE CONNECTING USB NC BOX TO PC. The supplied Parallel cable is connected from the Motor Stepper Controller to the PC or the USB NC converter. You will need a 5mm Allen Key to insert and fasten it (NOT TOO TIGHT! You do not want to compress the spindle bearings). The milling motor fits into the Euroneck holder on the bridge. The 2 lever switches on the front of the Controller can override the relays and be always on 220v (Zero2 controller only). One is for the mill and Two is for a vacuum/cooling system.Īt this time you should plug it into No1 socket. The Milling motor cable plugs in to one of these. You will notice that the Motor Stepper Controller has also got 2 Plug points for the German style plug. Unpack the milling motor and cable supplied. Always screw the connectors to the plugs to prevent any problems.( lazy here can result in problems later) The rest are clearly marked, Y,Z and ST (emergency stop switch) and the A for a 4th axis if you have one. There are 2 X ports on the Controller (any of the 2 X motors into any of the 2 X ports) Be careful not to damage any cables which are tied to the machine.įree the cables and plug them into the Motor Stepper Controller box.

Place the Machine on a suitable workbench. Unplug it and leave it unplugged before starting. Important Note! Motor stepper controller must be off for installation. Once the crate is open, you should unscrew any shipping mounts inside the crate to be able to remove your Heiz CNC platform and accessories. Carefully pry open the lid which is nailed down using a crowbar. Normally your machine will arrive in a large shipping crate. Learn everything about CNC here : SO THE CRATE HAS ARRIVED!įirst Check for damage to the crate before you accept the shipment from the driver delivering!

Cnc usb controller software download